Assembly Instructions
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
Installation
1.The planned mounting area must provide a flush fit to the bottom of the
Lights (1).
2.Remove the lens from each Light and use the base of the Light as a template to mark mounting holes.
3.Ensure that the installation area has no hidden electrical or stereo lines before drilling.
4.Drill the holes, then secure each of the Lights with two Long Screws (2). Replace the lens.
5.See Wiring Diagram, page 4.
6.Connect the wire of each of the Lights to the Lead Wire (8) using a Wire Splice (4). Insert the two wires into the holes of the Splice and use pliers (not included) to push down the metal tab. Close the cap to secure.
metal tab
8.If the Lights are to work independently of the vehicle’s lights, mount the Switch at a convenient location with the two Short Screws (3).
9.Connect the Lead Wire to the middle terminal of the Switch (7).
10.Connect the Fuse Holder (5) to the top terminal and connect to a 12V power supply.
11.Connect the Ground Wire (6) to the bottom terminal of the Switch and the other end to ground.
12.This product is intended only to be mounted on the top of a vehicle’s cab.
13.Installation of these products must comply with DOT regulations and all applicable State and local laws.
PLEASE READ THE
FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this document as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty
of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
holes for | cap |
wires | Wire Splice (4) |
|
7.If the Lights are intended to be used along with the vehicle’s main lights, connect the lead wire to the headlight switch positive terminal.
SKU | Page 2 |