ger (8), then release the Trigger (8) and the Spot Light will stay on.
3.When finished using the Spot Light, squeeze the Trigger to turn the Spot Light off. Let the Bulb (14) cool for at least 30 minutes before storing. Keep Spotlight indoors away from children.
Replacing the 4V Halogen Bulb:
1.Remove the Ring Cover (12) from the Housing (2) by
2.Lift out Ring (11), Lens (10), and
Reflective Bowl (9). The Bulb (14) is installed into base of Reflective Bowl.
3.Remove the Metal Spring Clip (22) holding the Bulb Holder in place by squeezing and lifting the Spring Clip up through the “T” slot.
4.NOTE: To prevent
5.Replace with new, identical Bulb (25W Halogen H3 4V).
6.Place Bulb Holder into the Reflective
Bowl (9). Slide the closed end of the Metal Spring Clip (22) over the tab at- tached to the side of the Bulb Holder, and squeeze the Spring Clip together while sliding it into the “T” slot.
7.Replace the Reflective Bowl (9), the
Lens (10), and the Ring (11). Hold these in place while threading the Ring Cover (12) onto the Spot Light with a clockwise motion.
Removing and Recycling the 4V DC Battery:
NOTE: The Battery for this product is rechargeable and long lasting. When finally it is worn beyond any further use, it should be removed and recycled and the Spot Light should be disposed of with normal refuse. DO NOT dispose of the Spot Light with Battery inclosed in it’s Housing.
Figure 2
Seven Screws
Hold Housing
Together
1.To remove the Battery from the Hous- ing (2), follow these steps:
a.Remove seven Screws from the Housing. See Figure 2.
b.Pull the Housing (2) apart and re- move the wires connected to the Battery.
c.Remove the Battery from the Hous- ing (2).
WARNING! DO NOT dispose of the 4V Lead Acid Battery with normal refuse. Always recycle in ac- cordance with all local, state and federal rules and regulations.
SKU 66691 | For technical questions, please call | Page 4 |