Work Piece and Work Area Set Up
1.Designate a work area that is clean and well‑lit. The work area must not allow access by children or pets to prevent distraction and injury.
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose work pieces using the clamp to prevent movement while working.
Safety
General Operating Instructions
CAUTION! Friction from cutting will heat both the Wheel and the workpiece. Be careful when handling the workpiece and do not overwork the
1.Release the Safety Chain and guide the Housing to rest at ifs full upward position.
2.Adjust the Angle Guide as needed.
3.Place the workpiece against the Angle Guide and the Clamp in place.
4.Plug the Power Cord into a 120V~ grounded, electrical outlet.
5.Squeeze and hold the Trigger to start the Saw.
6.With one hand on the Handle and the other hand clear, slowly bring the Saw down, letting the Saw do the work. Do not apply excessive force.
7.After making the cut, release the Power Switch and raise the Saw.
8.Wait until the unit comes to a complete stop then remove the workpiece.
9.To prevent accidents, turn off the tool and disconnect its power supply after use. Lower the Housing
and secure with the Safety Chain. Clean, then store the tool indoors out of children’s reach.
Setup
Operation
Maintenance
Item 69438 | For technical questions, please call | Page 9 |