Harbor Freight Tools 47613 operating instructions Unpacking, Assembly and Operating Instructions

Page 10

UNPACKING

When unpacking, check to make sure all the parts shown in Figure C are included. If any parts are missing or broken, please call Harbor Freight Tools at the

number shown on the cover of this manual as soon as possible.

Side Handle

Saw Blade

Saw Blade

Rip Guide

Removal Wrench

 

Figure C

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram on the last page page of this manual.

CAUTION: Always make sure the Power Cord Circular saw is unplugged from its electrical outlet prior to making any adjustments to the tool.

Adjusting The Saw Prior to Cutting

1.Screw the Side Handle (401) into the Circular Saw housing.

2.To adjust the angle of blade from 0 to 45 degrees, loosen Wing Nut (60) and move Base Assy. (52) down, observing the degrees indicated on the angle plate. Tighten Wing Nut (60).

See Figures D and E on the next page.

3.To adjust the depth of the cut, loosen Lock Handle (55) and move Base Assy. (52) down (or up) while observing the amount of saw blade exposed under base plate. Tighten Lock Handle (55).

SKU 47613

Page 10

Image 10
Contents 47613 Save this Manual Product SpecificationsGeneral Safety Rules Work AreaElectrical Safety Personal SafetyTool USE and Care Specific Safety Rules ServiceCalifornia Health & Safety Code 25249.5, et seq Grounding Grounded Tools Tools with Three Prong PlugsExtension Cords Double Insulated Tools Tools with TWO Prong PlugsSymbology Figure CAdjusting The Saw Prior to Cutting Assembly and Operating InstructionsUnpacking Figure D Prepare Material Before CuttingINSPECTION, MAINTENANCE, and Cleaning CuttingInstalling a New Saw Blade Replacing the Carbon BrushesPart Description Screw Part Description Int. Ret. RingAssembly Diagram Limited 1 Year warranty