Coleman 5040 manual Burner Screen Oval Hole Bottom

Model 5040 A Repair Manual

Caution: After completion of repairs and before operating the patio heater, make sure you read and follow all safety information in the Instructions for Use manual. If you do not have this manual, contact Coleman at 1-800-835-3278 or TDD 316-832-8707.

To repair or replace reflector, refer to Figure 1.

Remove four hex-head screws holding reflector to burner head using a 11/32" wrench (Figure 1). Also see Note #1.

To repair or replace burner screen, refer to Figures 1-5. To avoid cuts, do not run fingers or hands along edges of thin sheet-metal parts.

Remove reflector (Figure 1). Remove 4 lower hex-head screws holding burner screen to burner screen assembly bottom using a 7/16" wrench (Figure 2). Lift burner screen assembly top from heater head (Figure 3). Also see Note #1. Remove 4 upper hex-head screws holding burner screen to burner screen assembly top using a 7/16" wrench (Figure 4). Finally, remove burner screen assembly top (Figure 5). Reassembly caution: Edge of screen with holes closer to the edge goes “up” on re-assembly (attached to screen assembly top). When reinstallingburner screen make sure that the oval hole at the bottom edge of the burner screen (Figure 3-a) is lined up with the hole in the burner screen bottom, marked Pilot Port (Figure 3-b).

Figure 1 Figure 2 Figure 3

Burner Screen

Oval Hole

Figure 3-a

Burner Screen

Bottom

Figure 3-b

Figure 4 Figure 5

4