|
| Operation (continued) | |||
|
|
| FIGURE 1 | ||
|
|
| Air Inlet (9) | ||
| Blade Guard (34) | ||||
Blade |
|
|
| ||
|
| Pivot |
| Point of | |
(not included) |
|
| Throttle |
| Lever (13) |
| |||||
|
|
| Throttle Lever (13) | ||
|
|
| Throttle Safety | ||
|
|
| |||
Adding or Changing Blades
Warning! Always disconnect the Saw from the air source before adding or changing blades. After disconnecting the Saw from the air compressor, there could still be enough air pressure to activate the Saw. Always position the Saw safely and activate the Throttle Lever (13) repeatedly to make sure all of the air is expended.
Refer to FIGURES 2 and 3 below, and the Assembly Drawing on page 8.
1.The Blade Guard (34) may be removed when replacing blades, but it must always be on during operation. Using the Saw without the Blade Guard (34) can result in severe injury. To remove the Blade Guard (34), loosen and remove the two Set Screws (24). When replacing the Blade Guard (34), place it in the slots and tighten the Set Screws (24).
2.To change blades, first remove the Chuck Cover (26) by removing the Screw (38). Swing the Chuck Cover (26) back on its hinge.
3.Loosen the two Set Screws (30) inside, until the blade can be removed. Replace with a new blade and tighten the Set Screws (30). Replace the Chuck Cover (26) and carefully tighten the Screw (38). Do not overtighten the Screw (38) or you may break the plastic Chuck Cover (26).
Note: Never use a dull, bent, or cracked blade.
Check that the blade and blade guard are tight before each use.
FIGURE 2
| Wrench (31) | ||
Set Screw (24) |
|
| |
|
| ||
Housing (28) | |||
| |||
Blade
Blade Guard (34)
Screw (38)
FIGURE 3
Chuck Cover (26)
Blade
Wrench (36) Set Screw (30)
SKU 113 | Page 5 | REV 09f |
|
|