Specifications | Alignment | ||
|
| Tab | |
Electrical Input | 120 V~ / 60 Hz |
| |
Electrical Output | 22 VDC / 500 mA | Power | |
Charge Time | |||
Indicator | |||
Charging | 67029 - 18 V, 1.3 A, NiCd | ||
| |||
Capability | Battery Pack (sold separately) |
| |
|
| Figure 4B | |
Unpacking | |||
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
1.Place the Battery Pack on a dry fireproof surface in a room where the temperature is from
2.Allow the Battery Pack to cool completely before charging.
Make sure the battery pack is undamaged; do not charge a cracked or leaking battery pack.
3.Disconnect the Cord from the Charger. Attach the plug to a grounded, 120 V~, 60 Hz outlet.
Charger
Battery
Pack
4.Slide the Charger onto the Battery
Pack until it firmly rests in place against the alignment tab (see Figures 4A and 4B). If the Charger does not fit properly, disconnect it and confirm that the Battery Pack is the correct model for this Charger as shown on the Specification chart.
Do not charge any Battery Pack not listed or any Battery Pack that the
Charger does not securely fit.
5.Attach the Cord to the Charger. The Power Indicator will light to show that the power is connected.
6.For a fully discharged battery or a new battery, allow the Battery Pack to Charge for at least 3 hours.
Do not charge the Battery Pack longer than 5 hours.
WARNING! Time the charging cycle. The battery charger will not signal when charging is finished.
7.Unplug the Charger and disconnect it from the Battery Pack when finished.
8.Allow the Battery Pack to cool completely before using it.
9.Store the Charger and Battery Pack indoors, out of reach of children.
Figure 4A
| For technical questions, please call | REV 09h |
Page 6 | SKU 67031 |