Harbor Freight Tools operating instructions SKU 94088 For technical questions, please call

carburetor, fuel lines, or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block.

(g)When disconnecting charger, turn switches to off, disconnect AC cord, remove clip from vehicle chassis, and then remove clip from battery terminal.

(h)See operating instructions for length of charge information.

16.Follow these steps when battery is outside vehicle. A spark near battery may cause battery explosion. To reduce risk of a spark near battery:

(a)Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has larger diameter than NEGATIVE (NEG, N, -) post.

(b)Attach at least a 24-inch-long 6-gauge (AWG) insulated battery cable to NEGATIVE (NEG, N, -) battery post. Place the other end of this cable on a dry insulating surface, such as a piece of dry wood.

(c)Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery.

(d)Position yourself and free end of cable as far away from battery as possible- then connect NEGATIVE (BLACK) charger clip to free end of the cable.

(e)Do not face battery when making final connection.

(f)When disconnecting charger, always do so in the reverse sequence of connecting procedure and break first connection while as far away from the battery as practical.

(g)A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

SAVE THESE INSTRUCTIONS

SKU 94088 For technical questions, please call 1-800-444-3353. Page 5