Specifications
Input Power | 120V AC, 60 Hz, 2.2 Amps | Battery Leads | 6’ 7” Long x 16 AWG | |
|
|
|
|
|
Output Power | 12 | Volts DC - 10* Amps | Power Cord | 6’ 5” x 18 AWG |
| 12 | Volts DC - 2* Amps | ||
|
| |||
| 6 Volts DC - 10* Amps |
|
| |
| Engine Start - 55 Amps | Weight | 10 Lbs. | |
|
|
|
|
|
*Amperage is only present when the unit is connected to a battery or in START mode.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe and dry place for future reference.
Basic Safety Warnings and Precautions
WARNING:When using Charger, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this Charger!
1.Keep work area clean. Cluttered areas invite injuries.
2.Observe work area conditions. Do not use Charger in damp or wet locations. Don’t expose to rain. Keep work area well lighted. Do not use Charger in the presence of flammable gases or liquids.
3.Keep children away. Children must never be allowed in the work area. Do not let them handle the Charger.
4.Store idle equipment. When not in use, Charger must be stored in a dry location to inhibit rust. Always lock up Charger and keep out of reach of children.
5.Use the right tool for the job. Do not attempt to force a small Charger to do the work of a larger industrial Charger. There are certain applications for which this Charger was designed. It will do the job better and more safely at the rate for which it was intended. Do not modify this Charger and do not use this Charger for a purpose for which it was not intended.
6.Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically nonconductive clothes and nonskid footwear are recommended when working. Wear restrictive hair covering to contain long hair.
7.Use eye protection. Always wear ANSI approved impact safety goggles.
8.Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines.
9.Maintain Charger with care. Keep Charger clean for better and safer performance. Inspect tool cords periodically, and if damaged, have them repaired by a qualified technician. The clamps must be kept clean, dry, and free from oil and grease at all
times.
REV 12/05
SKU 03418 | For technical questions, please call | Page 2 |