Connecting the charger to a PC

Putting the charger into operation

You can connect one or several chargers to a PC. The supplied “Conference Control” software allows you to centrally and easily configure and monitor several chargers and receivers.

For this, the charger requires a network connection with a PC. The charger can be connected directly to an individual PC or integrated into an existing network. The charger cannot communicate with several PCs at the same time.

The charger also functions without connection to a PC.

Connecting the network cable

Use a standard network cable (RJ45 CAT.5E, not included in the delivery) to connect the network socket and an Ethernet socket of the network.

Install the “Conference Control” software.

Configure the network communication between the “Conference Control” software and the charger (the instruction manual of the “Conference Control” software on the enclosed CD).

Connecting the charger to and disconnecting it from the mains

CAUTION! Danger due to electric current!

If you connect the charger to an unsuitable power supply, this can cause damage to the device!

Use a mains cable with a 3-pin IEC mains connector to ensure a reliable mains ground connection of the charger – especially when you are using an extension cable or a multi-outlet power strip.

Avoid circuit overloading. If necessary, provide overcurrent protection.

To connect the charger to the mains:

Connect the mains cable (not included in the delivery) to the mains socket .

Plug the mains connector into a wall socket.

To disconnect the charger from the mains:

Pull out the mains connector from the wall socket.