Check Valve: When the air compressor is |
|
|
|
operating, the check valve is "open", allowing |
|
|
|
compressed air to enter the air tank. When the air |
|
|
|
| Check Valve |
| |
compressor reaches |
|
| |
|
|
| |
valve "closes", allowing air pressure to remain inside |
|
|
|
the air tank. |
|
|
|
Pressure Release Valve: The pressure release |
|
|
|
valve located on the side of the pressure switch, is |
|
|
|
designed to automatically release compressed air |
|
|
|
|
|
|
from the compressor head and the outlet tube when |
|
|
| Pressure | |
the air compressor reaches |
| Release |
shut off. The pressure release valve allows the motor to |
| Valve |
|
| |
restart freely. When the motor stops running, air will be |
|
|
heard escaping from this valve for a few seconds. No |
|
|
air should be heard leaking when the motor is running, |
|
|
or continuous leaking after unit reaches |
|
|
pressure. |
|
|
|
|
|
How to Use Your Unit
How to Stop:
1.Set the On/Auto/Off lever to "OFF".
Before Starting
Serious damage may result if the following
This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.
1.Make sure the On/Auto/Off lever is in the "OFF" position.
NOTE: If quick connect is installed, pull coupler back until it clicks to prevent air from escaping through the quick connect.
2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)
On/Auto/Off Switch
Regulator
3.Open the drain valve fully
NOTE: Always drain tank on a washable surface or in a suitable container to prevent damaging or staining surfaces.
4.Move the On/Auto/Off lever to "ON/AUTO" position. The compressor will start.
5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure
13- ENG | D26195 |