Fig. 1 Connection of the battery to the charging unit
3.1 Control connector BATTERY CONTROL
Various control input/outputs are available at the
-Input temperature sensor
-Output exhaustive discharge relay
-Failure signal output FAILURE
Fig. 2 Connections of the BATTERY CONTROL pin connector
Note The switch rating of the failure signal output amounts to max. 30V dc / 0.IA . The contacts 2, 3 and 13 are provided for test purposes only and must not be used.
4. Alteration of the mains voltage (to be performed by qualified personnel only)
Attention: Before removing the top unit cover, the device must have been disconnected from the mains for at least 2 minutes, since the capacitors in the device carry hazardous voltage which needs to discharge first.
For 115V AC operation, the mains powerfuse (6) must be replaced by a fuse 2A
For alteration to 115V AC operation, the wire jumpers S501, S502 and S504 on the PCB 85254 are to be soldered in and the wire jumper S 503 must be removed, (see Figure 3).
18