Plantronics WO200 manual Muting the Headset, Conferencing In Up to Three Additional Headsets

Muting the Headset

You can mute/unmute the headset the following ways:

HeadsetBase

Conferencing In Up to Three Additional Headsets

While on a call you can subscribe up to three additional headsets to your base for conferencing. As you add headsets to the base an additional headset icon will appear in the Plantronics software

Press the volume down button (at least 1½ seconds) until the base talk button indicator light for the active call becomes solid red.

Short press (less than one second) of a red desk phone or PC talk button on the base will unmute the headset. You cannot mute the headset using the desk phone or PC talk buttons.

screen with a number from 1 to 3 indicating the number of additional headset subscribed to the base.

Guests may conference in as described below:

1While you are on a call:

a)Place the guest’s headset into primary user’s charge cradle.

Subscribing a Master Headset

The headset and base are subscribed to each other at the factory. In the event that you need to subscribe a new master headset

to the base you can do so one of two ways. You can subscribe a master headset to the base with the headset docked (secure subscription) or undocked (over-the-air subscription). In either case, the system must be idle (not on a call).

Headset Docked Headset Undocked

OR

b)Place the guest’s headset into over-the-air subscription mode by pushing the headset volume up button for three seconds until the indicator light becomes solid green.

2	Short press (less than one second) the subscription
	button on the base.
	The subscription light will flash yellow and green.
3	The subscription light will then turn solid yellow and you

Double press the subscription button on the base. The subscription light will flash red and green.

When the subscription light becomes solid green, the headset and base are subscribed to one another.

Double press the subscription button on the base. The subscription light will flash red and green. Press the volume up button on the headset for three seconds until the headset indicator light turns solid green.

When the subscription light on the base becomes solid green, the headset and base are subscribed to one another.

will hear a tone in the master headset indicating a guest

wishes to join the call.

4 If you press the call control button on the master

headset within five seconds, the guest is joined to the

call.

If you do not press the call control button within five seconds,

the request to join the call is rejected and the guest will hear an

error tone in their headset.

5 Guests may leave the conference call by pressing their

call control button.

Note If the subscription process times out after two minutes or if the subscription process fails, the subscription light will become solid red for four seconds and then return to its previous state. If this occurs, try to re-subscribe the headset again.

When they do you will hear a single tone in the master headset as each guest leaves the call.

To see how many headsets are subscribed to the base, refer to the lower left corner of the Plantronics software screen. The first headset is the master headset and the number inside the next headset is the number of guest headsets subscribed to the base. The examples below show 1, then 2, then 3, guest headsets subscribed to the base in addition to the master headset.

123

Plantronics Savi User Guide 15