Porter-Cable 7412 instruction manual Assembly, To Install Auxiliary Handle, To Install Wheel Guard

Page 8

3.Slide the switch button (A) Fig. 1 forward to turn the tool “ON”. When released, the switch button will return to the "OFF" position.

4.To lock the switch in the “ON” position, move the switch to the “ON” position and depress the front end of the switch button (A) Fig. 1. To release the switch lock, depress the rear end of the switch button.

A

Fig. 1

Allow the tool spindle to stop rotating before putting the tool down.

ASSEMBLY

H

A B

Fig. 2

Fig. 3

TO INSTALL AUXILIARY HANDLE

An auxiliary handle (H) Fig. 2 is furnished with this tool and can be installed on either side of the front housing. This handle should be used AT ALL TIMES to maintain complete control of the machine.

TO INSTALL WHEEL GUARD

A TYPE 27 wheel guard is furnished with the machine. A TYPE 1 wheel guard is available as an accessory. (See “ACCESSORIES”). Both guards are installed and adjusted in the same manner.

Always use an approved and properly adjusted wheel guard. (See “ACCESSORIES”).

DISCONNECT TOOL FROM POWER CIRCUIT.

1.Rest the tool on its back with spindle facing up.

2.Align the protrusion (A) Fig. 3 on the guard flange with the slot (B) Fig. 3 on the mounting flange of the gear housing cover.

8

Image 8
Contents Instruction Safety Guidelines Definitions General Safety RulesElectrical Safety Work AreaPersonal Safety Tools USE and CareSpecific Rules and Symbols ServiceAdditional Safety Rules for Paint Removal Replacement Parts MotorExtension Cord Selection Functional DescriptionForeword To Start and Stop the ToolTo Install Wheel Guard AssemblyTo Install Auxiliary Handle To Install Grinding Wheel To Install Wheel Guard section of this manualMaintenance OperationAccessories Service and RepairsPORTER-CABLE Limited ONE Year Warranty Canadian PORTER-CABLE Delta Service Centers