Porter-Cable DP350 instruction manual Being Careful not to Overtighten

4.Slide raising rack (F) Fig. 7, table and table bracket onto drill press column, as shown. Make sure bottom of raising rack (F) Fig. 8, is inside the flange (J) on drill press base.

5.Re-assemble ring (E) Fig. 9, which was removed in STEP 1. IMPORTANT: Bottom of ring (E) MUST NOT be pushed all the way down onto top of raising rack (F). MAKE SURE top of raising rack (F) is under bottom of ring

(E) and that there is enough clearance to allow rack (F) to rotate around the column. THEN TIGHTEN SET SCREW

(D) BEING CAREFUL NOT TO OVERTIGHTEN.

6.Assemble table raising and lowering handle (K) Fig. 10, to worm gear shaft (G) and tighten screw (L) against flat on shaft.

F

Fig. 7

F

J

Fig. 8

E

DF

Fig. 9

G

L

K

Fig. 10

8