| SPECIFICATIONS |
Free Speed (No Load) | 23,000 RPM |
Maximum Working Pressure | 90 PSI |
Air Inlet | 1/4" NPT |
Recommended Hose Size | 3/8" I.D. |
Cutting Wheels | 3" |
Air Consumption @ 90 PSI | 5.5 SCFM |
|
|
| ASSEMBLY |
|
|
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.
OPERATION
Operation
Before each use:
●Drain water from air compressor tank and condensation from air lines. See air compressor’s operators manual.
Disconnect the
wheels
●Lubricate tool, see “Maintenance” section in this manual.
Make sure cutting wheels are securely fastened.
Loose cutting wheels could come off the tool when operating and cause serious injury.
Cutting
Wheel
Air Inlet
Throttle
Control
Lever
Throttle
Safety
Release
●Holding collet with wrench (D), remove hex head screw
(A) and washer (B). NOTE: Wrench and Hex wrench are supplied.
Inspect and clean spindle before mounting cutting wheel.
●Position cutting wheel (C) onto collet.
●Replace washer (B) and hex head screw (A), hold collet with wrench (D) and tighten securely.
●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is recommended.
To use:
●Turn air compressor on and allow air tank to fill.
D B
A
D C
B A
5- ENG