THE EDGE GUIDE
W
Z
X 
W 
Y
Fig. 13
An accessory edge guide is available to aid in straight edge planing, parallel grooving, dado, or slotting operations.
To attach, insert the grooved end of the guide rods (W) Fig. 13, in holes in base and secure with two screws (X). (NOTE: These screws should engage the groove in the guide rod.) Slide the guide (Y) Fig. 13 on the rods, and adjust to the desired position. Secure with the two thumb screws (Z).
TEMPLATE GUIDES
LOCKNUT
ROUTER
BASE
TEMPLATE GUIDE |
|
| ||
| ||||
ROUTER |
| BIT |
|
|
|
| Fig. 14 | ||
A wide variety of template guides is available for use in pattern and templet routing operations. A typical combination bit, template guide, and locknut are illustrated in Fig. 14.
DISCONNECT TOOL FROM POWER SOURCE.
To install, insert the template guide in the center hole of the router base and secure with the locknut.
Before connecting the router to the power source, install the bit, adjust the depth of cut, and rotate the chuck by hand to confirm that the bit or collet will not contact the template guide.
15