LUBRICATING THE CHAIN
Lubricate the chain case every six months, or once a month if the sander is in constant use.
Disconnect tool from power source.
Fig. 8
1.Lay the tool on its right side and remove the cover (Fig.8).
2.Clean and repack the chain case to approximately half of its capacity with
DRIVE CHAIN CARE
Replace the chain when the chain links become loose on the pins.
BRUSH INSPECTION (If applicable)
For your continued safety and electrical protection, brush inspection and replacement on this tool should ONLY be performed by an AUTHORIZED
At approximately 100 hours of use, take or send your tool to your nearest authorized
Any loss of power before the above maintenance check may indicate the need for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION. If proper operating voltage is present, return your tool to the service station for immediate service.
SERVICE
REPLACEMENT PARTS
When servicing use only identical replacement parts. For a service parts list or to learn more about
SERVICE AND REPAIRS
All quality tools will eventually require servicing, or replacement of parts due to wear from normal use. For assistance with your tool, visit our website at
Should you have any questions about your tool, feel free to write us at any time. In any communications, please give all information shown on the nameplate of your tool (model number, type, serial number, etc.).
15