Porter-Cable 340 instruction manual Paper Punch

900008 - 04-29-02.qxd 5/23/02 2:17 PM Page 8

Fig. 3

PAPER PUNCH

A Paper Punch is provided with Model 340 Sander. The punch is used to make eight holes through the abrasive. These holes allow the sanding dust to be extracted directly through the pad. The punch can be mounted to a workbench or wall using four No. 8, flat head, screws (see Fig. 5). Use the punch as follows:

Fig. 4

Fig. 5

1.CAUTION: DISCONNECT TOOL FROM POWER SOURCE.

2.Install the abrasive to the sander as described in the ATTACHING STIKIT™ ABRASIVE section, or the ATTACHING CONVENTIONAL ABRASIVE section of this manual.

3.Position the sander to the punch (see Fig. 6), aligning the sander pad with the two corner guides on the punch. Push sander onto the punch until seated (see Fig. 7).

4.Remove sander from punch.

Fig. 6 Fig. 7

8