2.Position one handle and grip assembly into clamp on left side of tank assembly, as shown in Figure. Align hole in handle with hole in clamp. Insert bolt (N) through the hole (in clamp and handle). Thread nut (O) onto bolt. Using two 1/2" wrenches (not furnished) tighten nut securely.
3.Repeat step 2 to assemble remaining handle and grip assembly to the clamp on the right side of tank assembly.
4.Using a 9/16" socket wrench (not furnished) remove the four bolts securing the compressor to the shipping skid.
A.Place spacer (S) on flat side of a rubber foot (R). Place spacer and rub- ber foot against compressor frame as shown in Figure.
B.Align hole in spacer and rubber foot with one of the smaller holes adja- cent to the holes where shipping skid was attached.
C.Insert one of the
D.Repeat A through C to install the three remaining rubber feet.
Lubrication and Oil
Engine
Drain tank to release air pressure before removing the oil fill cap or oil drain plug.
1.The engine was filled WITH oil at the manufacturer. Check engine oil level before operating unit. If necessary, fill engine to the appropriate level with recommended oil, see engine manual supplied by engine manufacturer for correct procedure.
2.Add fuel to engine. See engine manual supplied by engine manufacturer for correct procedure.
Gasoline vapor is highly flammable. Refuel outdoors preferably, or only in
check gasoline level while the engine is running. Do not store, spill, or use gasoline near an open flame, a source of sparks (such as welding), or near operating electrical equipment.
Air Compressor
The air compressor pump was filled WITH oil at the manufacturer. Check air compressor pump oil level before operating unit. If necessary, fill pump to the appropriate level with approved compressor oil, see the Maintenance section of this manual for details.
D26998 |