Porter-Cable 352VS instruction manual Fast Sanding on Rough Work, Removing OLD Paint and Varnish

Page 10

5.Work back and forth over a fairly wide area to obtain an even surface.

6.Do not let the tool tilt. The edge of the belt can make a deep cuts into the surface.

7.Do not pause in any one spot during the sanding operation. The belt will eat into the work and make the surface uneven.

8.Lift the tool from the work before turning the motor off.

9.Always be sure that the motor has completely stopped before putting the tool down.

FAST SANDING ON ROUGH WORK

To smooth a rough surface quickly, use a coarse grit abrasive belt. With the belt positioned diagonally across the grain, move the tool in the direction of the grain (Fig. 5).

Overlap the strokes and cover the entire surface, working from both sides of the board (angle left and then angle right.) Smooth the surface by guiding the sander back and forth with the grain. Change the belt to a medium grit and follow the same procedure.

Fig. 5

Finish by thoroughly working the grain lengthwise. Change again to a fine grit and repeat. Always finish sanding with the grain.

REMOVING OLD PAINT AND VARNISH

Read and follow “ADDITIONAL SAFETY RULES FOR PAINT REMOVAL” section of this manual.

The 352VS is an excellent tool for removing old paint and varnish from flat surfaces. However, two problems are common: 1) sanding material that loads the abrasive and, 2) friction heat caused by working too long in one place. To overcome the loading problem, use a coarse grit open coat abrasive belt and a single stroke action. Overheating can be avoided by using a fairly quick stroke and moving to another area quickly. A piece of felt about 1/4" thick can be inserted under the shoe for fast spot sanding and for working on stubborn areas of paint and varnish.

SPECIAL SANDING PROCEDURES

Generally, the operator should sand with a back and forth motion. Some materials and some types of operations, however, require a different technique. In rough sanding, use the tool at an angle. In spot sanding, use the tool with only the front pulley touching the surface (especially useful in smoothing excess glue from wood joints). On metals, slate, marble, or plastic materials, sanding can be done in all different directions because of a lack of grain.

109

Image 10
Contents Belt Sander Electrical Safety Work AreaPersonal Safety Tools USE and CareService Specific Safety Rules and SymbolsAdditional Safety Rules for Paint Removal Motor Replacement PartsExtension Cord Selection Installing and Removing the Abrasive Belt ForewordVariable Speed To Start and Stop the Belt SanderTracking the Abrasive Belt Selecting AN Abrasive Belt Attaching and Care of Dust BAGGeneral Sanding Fast Sanding on Rough Work Special Sanding ProceduresRemoving OLD Paint and Varnish Good Sanding Technique Doors and Mill WorkSanding Metal Failure to Start Keep Tool CleanService and Repairs LubricationAccessories PORTER-CABLE Limited ONE Year Warranty Alberta Manitoba Québec