Features, Submittal Data | Bryant 580F036-150 instruction

580F units are a single piece, gas heating/electric cooling unit, with a low profile, pre-wired, tested and charged at the factory. The units have the capability for convertible supply and return open- ings and are intended for installation on an acces- sory curb (ordered separately), or for slab mounting (for horizontal duct connections). Units are designed to accept a field-installed economizer, enthalpy control, manual or 2-position outside air damper, roof curb, as well as up to 3 choices of gas heat. Refer to accessory chart for full listing.

FEATURES

•Standard one-year full product warranty.

•Five-year protection plan for the motor- compressor.

•Five-year protection plan on heat exchangers.

•Outdoor ambient cooling operation from 25 F (–4 C) to 115 F (46 C).

•Units are tested and certified by ARI and certi- fied by UL and CSA. Factory-run test printout included in each rooftop.

•24-volt control circuit, with resettable breaker.

•Two-inch disposable-type return air filters in ded- icated rack.

•Hermetic compressor on independent circuit with internal line break and overload protection, self- lubricating with internal discharge muffler.

•Refrigeration circuit contains a filter drier to trap dirt and particles.

•Two-speed direct-drive evaporator fan on sizes 036-060. All other sizes are belt driven. Adjustable belt-drive fans are optional on 036- 060 sizes.

•Non-corrosive condensate pan with self-draining design with both bottom and side drain connections.

•Thru-the-bottom power, control and gas entry capability.

•Indoor and outdoor coils constructed of alumi- num fins mechanically bonded to seamless copper tubes.

•Single point electrical and gas connections.

•Direct-drive propeller condenser fan totally enclosed with permanently lubricated bearings.

•Pre-painted, insulated cabinet with primed inner panels, certified 500-hr salt spray test and non- corrosive screws.

•Large, easily removable panels provide ready access to unit components for rapid removal or maintenance.

HEATING & COOLING SUBMITTAL

DuraPac Series

Unit 580F036-150

3 to 121/2 NOMINAL TONS

COMMERCIAL SINGLE-PACKAGE

ROOFTOP GAS HEATING/ ELECTRIC COOLING UNITS

SUBMITTAL DATA

Job Name ______________________________________

Architect _______________________________________

Engineer _______________________________________

Contractor _____________________________________

Unit Designation _________________________________

PERFORMANCE DATA

Cooling

Net Total Cap. ________________________________Btuh

Net Sensible Cap. _____________________________Btuh

Compressor Power Input _________________________ kW

_______________________________ F Outdoor Air Temp.

Indoor Entering Air	db_________ F	wb _________ F
CFM ____________	Ext. Static Pressure ____ (in. wg)

Fan RPM ____________________________________ Bhp

SEER/EER______________________________________

Heating

Input: Stage 1 ______________ Total ___________Btuh

Output: Stage 1 ______________ Total ___________Btuh

AFUE _________________________________________ %

Steady State ___________________________________ %

Operating Weight ________ lbs. (unit) _______ lbs. (curb)

ELECTRICAL DATA

Power Supply to Unit ______ Volts _____ Phase _____ Hz

Minimum Circuit Amps ______________

Maximum Overcurrent Protection (Fuse Only) ___________