5.Snap the outdoor temperature/humidity sensor into place on the mounting bracket.
B.MOUNTING WITH ADHESIVE TAPE
1.With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.
2.Remove the protective strip from one side of the tape. Press firmly into the designated area on the back of the mounting bracket.
3.Remove the protective strip from the other side of the tape, and position the outdoor temperature/humidity sensor in the desired location.
C.MOUNTING USING THE BRACKET AS A STAND
The mounting bracket can be used as a stand by simply attaching the bracket to the bottom of the temperature/humidity sensor. Once snapped in place the sensor can then be placed on a shelf, table or other surface where the temperature and humidity measurements are desired.
III.MAINTENANCE AND CARE
1.Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units
2.Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents, they may mark the displays and casings
3.Do not submerge in water.
4.Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer.
5.Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technology for repairs.
IV. SPECIFICATIONS
Temperature measuring | ||
resolution | ||
range | ||
| ||
|
| |
Relative Humidity | 1% to 99% with 1% | |
measuring range | resolution) | |
| Every 10 seconds in first 3 | |
Transmission interval | minutes | |
| Every 1 minute thereafter | |
Transmission frequency | 433.92 MHz | |
|
| |
Power source | 2 x 1.5V AA Battery | |
Alkaline recommended | ||
| ||
Dimensions (H x W x D) | 6.3” x 2.95” x 2.2” | |
(160 x 75 x 55mm) | ||
|