Multiquip SP118 Specific Tools to be Used, Damaged or worn blades and replace with fresh blade

Page 23

INSPECTION/setup

3.Check V-belt tension by using a tension meter (3.0 lbs./1.36Kg) against the inside belt at a mid point between the two pulleys, or by deflecting the center belt at a mid point 3/16" (5 mm).

Figure 9. V-Belt Alignment

4.DO NOT over or under tighten the V-belts. Severe damage can occur to the saw and engine crankshaft if the belt is over-tensioned. A decrease of power to the blade and poor performance will result if the belt is under-tensioned (loose on pulleys).

NOTICE

V-belt alignment must be rechecked after adjusting belt tension.

SPECIFIC TOOLS TO BE USED

This saw is to use tools (blades) as follows:

Steel Core Segmented or Continuous Diamond Rim Cutting Wheel.

Any other type of tool is not to be used. See Table 6 for specific blade usage for material.

WARNING

Failure to thoroughly inspect the diamond blade (Figure 10) for operational safety could result in damage to the blade or the saw, and may cause injury to the user or others in the operating area. Discard

damaged or worn blades and replace with fresh blade.

SP118 Pavement Saw • operation manual — rev. #1 (05/03/12) — page 23

Image 23

Contents This Manual Must Accompany the Equipment AT ALL Times Model sp118Proposition 65 Warning Respiratory Hazards Silicosis/Respiratory WarningsSilicosis Warning SP118 StreetPro Table of ContentsChoose from three easy options Completely Training ChecklistTraining Checklist Description OK? DateSafety stop switch operation Braking control operation Daily PRE-OPERATION ChecklistDaily pre-operation Checklist Symbol Safety Hazard Safety InformationSaFeTY meSSageS SaFeTY SYmBolSGeneral SaFeTY Saw SaFeTY Before servicing equipment BlaDe SaFeTYEngine SaFeTY „ Use well-insulated gloves when picking up the battery Fuel SaFeTYBaTTerY SaFeTY eleCTriC STarT onlY TranSporTing SaFeTY LiFTing SaFeTYLabel must remain with the engine for its entire life EnvironmenTal SaFeTY/DeCommiSSioningEmiSSionS inFormaTion Emission Control labelPage Saw Specifications DIMENSIONS/SPECIFICATIONSDimensions Engine SpecificationsEngine Specifications Noise and Vibration EmissionsBlade Rotation General InformationIntended USE Components ComponentsEngine Components Basic engineFuel Check INSPECTION/setupInspection/setup Engine Oil CheckBelt Alignment and Tensioning Guards And CoversBlade Guard Inspection Belt CheckDamaged or worn blades and replace with fresh blade Specific Tools to be UsedHighlights the components of a diamond blade BladesMaterial Listing And Blade Selection Blade PlacementDiamond Blades Blade SpeedBLADEs Blade Removal and ReplacementCalibrating the Desired Depth of Cut RAISE/LOWER and Depth StopSTART-UP OperationEngine Fuel Valve Lever Mark the cutting line clearly and always saw in a OperationRestarting After Intervention OperationChassis Lubrication MAINTENANCE sawFront Pointer Adjustment General CleanlinessMAINTENANCE engine Illustration shown below is provided for reference Decommissioning/water tank optionalDecommissioning SAW/Components Water Tank KIT OptionBlade Troubleshooting Troubleshooting SAWTroubleshooting Engine Troubleshooting EngineDeclaration of Conformity Conformity CertificatesNew York, NY Tel 212 642 FAX 212 398 HERE’S HOW to GET Help