Table 7. Various displays in Test Mode
Stage in Test | Various displays (toggled by pressing DISPLAY key) | ||||
mode | Voltage (V) | Current (mA) | *Time (hh:mm) | Capacity | |
(mAh/ Ah) | |||||
|
|
|
| ||
During charging |
| Charging current | Charging time | ||
| elapsed | ||||
|
|
|
| ||
During |
| Discharging | Discharging time | ||
discharging |
| current | elapsed | ||
|
| ||||
During 2nd | Instantaneous |
| 2nd charging | Capacity of the | |
Charging current | battery | ||||
charging | Battery voltage | time elapsed | determined in | ||
| |||||
|
|
|
| discharging | |
|
| Trickle charging | Discharging time | Capacity of the | |
Full stage |
| battery | |||
| current | elapsed | determined in | ||
|
| ||||
|
|
|
| discharging |
28
THE SIZE C AND SIZE D BATTERY ADAPTERS (FREE ACCESSORY)
The battery adapters are used for connecting the AA battery to devices requiring Size C or D batteries. To apply the adapter:
1.Install the AA battery into the Size C or Size D adapter as below.
30
Note:
*The timer will be resumed and counted from 00:00 again after the time elapsed is longer than 20 hours. (For example, 1:45 will be shown after the battery has been refreshed for 21 hr and 45 min.)
In case the power source is shortly interrupted or terminated when the charger is being operated, the operational mode will automatically be set to “Charge mode at 200 mA” to charge up the battery once the power source is back to normal, regardless the operating mode (Charge, Discharge, Refresh or Test) which has been selected by user before.
29
The AA battery used with the | The AA battery used with the Size D |
Size C adapter | adapter (it is required to place the |
| battery into the “C” adapter first |
2.Ensure the polarity is correct and the assemblingandconditionthen theis“D”goodada. pter)
Note:
User shall stop using the adaptor when there are any cracks or damages observed in the adaptor, and in case undesired smell comes out while applying the adapter in certain kinds of battery operated devices.
CARE AND MAINTENANCE:
Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit
When cleaning the displays and casings, use a soft damp cloth only. Do not wet the exposed metal part of the charging unit. Do not use solvents or scouring agents as they may mark the LCD and casing.
Do not spill water to the charging unit.
Do not make any repair attempts to the units. Return it to its original point of purchase
31