CSL105V_ManualEN_072807.qxp 8/3/07 5:45 PM Page 4
Controls and Indicators
RUBBER
BEZEL HANGING
HOOK
HALOGEN
BULB
ON/OFF SWITCH
FUSED DC PLUG &
HEAVY DUTY CORD
OPERATING INSTRUCTIONS
1.Insert the Fused DC Plug into the accessory socket of your vehicle or a portable 12 volt power source.
2.To turn the unit ON, slide the
3.To turn the unit OFF, release the
USING THE HANGING HOOK
The Hanging Hook allows you to position the unit for convenient,
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
•When Hanging Hook is in use, do not shake light.
•When light is hung by the Hanging Hook, do not shake the light or object that it is hanging from. Do not hang the light from any electrical wires or anything that it is not secure.
•Only use the Hanging Hook for hanging this unit. The Hanging Hook is not intended to support additional weight. Do not attach or hang anything additional to the light or risk of breakage may occur.
CARE AND MAINTENANCE
This unit is NOT waterproof. Never submerge this unit in water. If it gets dirty, gently clean the outer surfaces with a soft cloth moistened with a mild solution of water and detergent.
Fuse Replacement (Fused DC Plug)
If the unit is plugged in to a functioning 12 volt DC power source, but will not light, the internal 8 amp fuse in the Fused DC Plug may be blown.
1.Unscrew the flange of the Fused DC Plug (counterclockwise).
2.Remove the end contact, flange and fuse.
3.Inspect the fuse to see if it is good or blown.
4.Replace with a new 8 amp fuse, if needed.
5.Carefully reassemble the fuse, end contact and flange. Do not overtighten the flange (clockwise).
4