Before first use / Preparing the tool for use
battery pack 6 forward out of the charging station.
7.Push the battery pack 6 from the front into the device to insert the battery pack 6 into the device.
QChanging tools
Your cordless electric drill / screwdriver has a fully
automatic spindle lock 
and is fitted with an enclosed keyless chuck incorporating the latest
technology from 
”Made in Germany”.
Once the motor has come to a halt, the drive shaft is automatically locked, so that the chuck 9 can be opened simply by turning it 
.
After you have inserted the required bit and fixed it in place by turning the chuck 
, you can immedi- ately continue working. The spindle lock releases itself automatically when the motor is started (by operation of the ON / OFF switch 4 ).
Q2 Gear Drive
Note: Move the gear selector switch 1 only after the device has come to a standstill.
Failure to observe this advice may result in damage to the device.
In the first gear (Gear selector switch 1 in Position: 1)
A speed of up to approx. 400 rpm can be achieved and a high torque. This setting is intended for use with all screwing tasks and for accessories.
In the second gear (Gear selector switch 1 in Position: 2)
It achieves a speed of up to approx. 1200 rpm, for the carrying out of drilling tasks.
QTorque pre-selection
You can adjust the torque by using 8 torque pre- selection.
When the value of the torque setting is reached, the clutch disengages the drive connection to the chuck. By doing this, screws can be driven to a predeter- mined depth, which is ideal for repetitive work.
jSelect a low setting for small screws, soft work material.
jSelect a high setting for large screws, hard work materials and for the extraction of screws.
jFor drilling, push the selector to the setting for drilling, in that you adjust the torque 
.
jFor drilling tasks, also push the gear selector switch 1 to the front (Position: 2).
QPreparing the tool for use
QSwitching On /Off
mCAUTION! Make sure the device not operat- ing when it contacts the screw. A rotating inserted tool may slip. This could result in personal injury or damage to the workpiece.
Switching on:
jTo start the appliance squeeze on the ON / OFF switch 4 and then keep it pressed down.
Switching off:
jTo stop the appliance, release the ON / OFF switch 4 .
QAdjusting the speed
The ON / OFF switch 4 has a variable speed regulator.
jBy increasing the pressure on the ON / OFF switch 4 you can increase the R.P.M.
GB/IE
11