Specifications, Assembly, Operation | PYLE Audio PT502 manual

	SPECIFICATIONS
Maximum Torque	500 ft./lbs
Blows Per Minute	1,000
Maximum Working Pressure	90 PSI
Air Inlet	1/4” NPT
Recommended Hose Size	3/8” I.D.
Air Consumption @ 90 PSI	4.2 SCFM

	ASSEMBLY

Accessories Required

IMPORTANT: Line pressure or hose inside diameter should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D. and fittings should have 1/4” NPT thread.

OPERATION

Operation

Before each use:

●Drain water from air compressor tank and conden- sation from air lines. See air compressor’s operators manual.

Disconnect the tool from the air supply before lubricating or

changing sockets.

●Lubricate tool, see “Maintenance” section in this manual.

Impact wrench sockets and accessories must be used with

this tool. Do not use hand sockets and accessories.

●Select the required impact socket. This tool has a 1/2" square drive, use 1/2” deep sockets. Use 1/2” extensions only when needed.

1/2” Square Drive

Trigger

Air Inlet

●Connect tool to air hose of recommended size. NOTE: The use of a quick connect set makes connecting easier.

IMPORTANT: The use of air filters and air line lubricators is recommended.

To use:

●Turn air compressor on and allow air tank to fill.

●Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum 90 PSI pressure.

●Set torque regulator, see chart, to set the desired setting to avoid over

	tightening.	Line desired torque # up with
IMPORTANT: These torque values can vary		Line desired torque # up with
IMPORTANT: These torque values can vary		indent
depending on the size of the air compressor
and the cubic feet of air (SCFM) the air		#1 approximately 200-275 ft./lbs. Torque
compressor delivers.		#1 approximately 200-275 ft./lbs. Torque
compressor delivers.		#2 approximately 275-350 ft./lbs. Torque
●	Place tool in forward or reverse position. #3 approximately 350-425 ft./lbs. Torque
	Place in “F” position for forward or “R”	#4 approximately 425-500 ft./lbs. Torque
	Place in “F” position for forward or “R”
	position for reverse.
●	Depress the trigger to operate tool.
	Depress the trigger to operate tool.
●	Release trigger to stop tool.
	Release trigger to stop tool.
●	Always disconnect air supply when changing sockets.
	Always disconnect air supply when changing sockets.
●	When job is complete, turn the air compressor off and store as described in the air

	compressor operator manual.

5- ENG

D22724

SPECIFICATIONS

ASSEMBLY