PYLE Audio 352VS instruction manual Assembly Operation, Installing and Removing the Abrasive Belt

ASSEMBLY

NOTE: This tool is shipped completely assembled. No assembly time or tools are required.

OPERATION

INSTALLING AND REMOVING THE ABRASIVE BELT

DISCONNECT TOOL FROM POWER SOURCE.

1.Place the sander on its left side.

2.Pull the lever (A) Fig. 1 out toward the front of the machine to retract the idler pulley (B) and release the tension on the abrasive belt.

3.Remove the old belt.

4.Install the new belt with the arrow (printed on the inside of the belt) on the top and pointing TOWARD the idler pulley.

B

A

Fig. 1

NOTE: Some sanding belts are bi-directional. These belts will not have arrows printed on them. They can be installed to run in either direction.

5.Engage the front pulley by pushing the lever (A) Fig. 1 back to its original position.

TO START AND STOP THE BELT SANDER

1.Be certain that the the switch is off and the power circuit voltage is the same as the voltage shown on the specification plate. Connect the machine to a power circuit.

2.Squeeze the trigger (A) Fig. 2 to start the motor. Release the trigger to stop the motor.

3.To allow the motor to run without constantly holding the trigger, press the trigger switch (A), push the lock button (B) Fig. 2, and release the trigger switch.

4.To release the lock button, squeeze the trigger and release.

B

A

C

Fig. 2

10