4.Tighten the hex nut on the fence handle against the fence pivot block (Figure 2).
Pivot Block
Fence
Handle
Hex Nut
Figure 2. Fence handle components.
5.Install the resaw fence lock handle (with the 8mm washer and moving plate) onto the fence, then slide the resaw fence over the moving plate as shown in Figure 3.
Note: Leave the moving plate and lock handle loose enough to slide on the resaw fence.
Resaw Fence |
Resaw Lock |
Handle |
Moving |
Plate |
Figure 3. Example of attaching resaw fence to
standard fence.
6.Tighten the resaw lock handle.
7.Pull the fence handle up and place the fence assembly on the rail.
8.Push the fence handle down to lock the fence assembly in place.
-2-
Test Run
1.Follow Steps 1-3in the G0566 Manual on
Page 24.
2.Verify that the machine is operating correctly by turning the switch disabling key (Figure 4) to "1" and turning the machine ON.
—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.
—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.
Figure 4. G0531B switch disabling key and ON/
OFF switch.
3.Press the OFF button to stop the machine.
4.WITHOUT resetting the OFF button, press the ON button. The machine should not start.
—If the machine does not start, the OFF but- ton safety feature is working correctly.
—If the machine does start (with the stop button pushed in), immediately disconnect power to the machine. The OFF button safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.
Model G0531B/G0566B
