OPERATIONS
Inserting and Removing Bits
UNPLUG TOOL WHEN CHANGING BITS
1.Push the silver spindle lock button on the side of the cutter and turn silver collet with fingers until the lock engages.
2.Use the supplied wrench to loosen the silver collet while continuing to push the spindle lock button.
3.Slide the desired bit into the collet as far as possible without covering the bit’s cutting edge.
4.With the spindle lock button still pressed, tighten the collet with the supplied wrench until securely seat- ed. Do not over tighten.
Operating the cutting tool
1.With appropriate bit in place, turn power switch on and slowly engage bit into or against the material to be cut. Do not turn power on while the bit is resting against surface to be cut.
2.If at any time during the cut the blade stalls or stops abruptly, turn power off immediately and wait for blade to come to rest before removing from material.
3.Do not make a blind cut into a wall without first determining if there are hazards behind the material to be cut. Check behind walls for wires, other electrical hazards, or plumbing.
4.Make sure to use the appropriate bit for the specified cutting task.
Operating this equipment has the potential for flying debris to cause eye injury. Always wear safety glasses or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
Like all power tools, there is danger associated with the Model H0604. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this tool with respect and caution to lessen the possibility of operator injury. If normal safety pre- cautions are overlooked or ignored, serious personal injury may occur.
H0604 Cutting Tool |