Grizzly G1258 instruction manual Assembly, Fence

Page 11

SECTION 4: ASSEMBLY

Fence

Most of your G1258 20'' bandsaw has been assembled at the factory. Only the fence assem- bly requires installation.

To mount the fence to the bandsaw table:

1.Mount the front rail to the table using the 2 516-18 x 212'' Cap Screws and the 2 Spacers provided. See Figure 2.

2.Loosen the fence lock knob and slide the fence onto the rail.

DO NOT attempt any step of assembly, adjustments, or maintenance while your Model G1258 is running. Ensure that the switch is off, power is disconnected and moving parts have stopped before making adjustments. Failure to comply may result in serious personal injury.

Figure 2. Front rail in place and fence installed.

G1258 20" Bandsaw

-9-

Image 11
Contents Bandsaw Page Table Of Contents Safety Instructions For Power Tools SafetySafety Instructions For Power Tools Additional Safety Instructions For Bandsaws Grounding FusingCircuit Requirements 220V OperationCommentary IntroductionParts Inventory UnpackingSite Considerations Clean UpFence AssemblyTrackingTension AdjustmentsUpper Guides Wheel AlignmentLower Guides Changing Blades Positive Table Stop Location of positive stop adjustment G1258 20 BandsawTest Run OperationsOverview Proper method for resawing lumber Blade Information ResawingStacked Cuts Cutting CurvesLubrication MaintenanceGeneralTable Closure Machine Data Sheet Parts Diagram and Parts List Description Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC