Model G4570, Accu-Sharp, Grinding JIG

MODEL G4570

ACCU-SHARP®

GRINDING JIG

INSTRUCTIONS

To reduce the risk of serious injury when using this grinding jig, take the following precautions:

1.GRINDER OWNER'S MANUAL. Read and understand the owner's manual for your grinder and always follow all of the safety precautions and instructions for your grinder.

2.EYE/FACE PROTECTION. Always wear safety glasses or a face shield to protect yourself from flying material.

3.HAND PLACEMENT. Always keep your hands and fingers away from the spinning grinding wheel, and protect yourself from the sharp edges of the tool.

4.SECURE CLAMPING. Make sure the tool is securely clamped in the jig and that the table is firmly locked in the proper posi- tion.

Introduction

The Model G4570 Accu-Sharp®Grinding Jig works with the tool rest table of your grinder, such as the Grizzly Model G1036 Slow Speed Grinder, to properly position chisels and plane irons up to 2 3⁄4" wide, as shown in Figure 1. The tool clamp- ing jig uses a special plastic rod and pads to slide the tool from side-to-side across the auxiliary table and the grinding wheel.

If you need help with your new grinding jig, call our Tech Support at: (570) 546-9663.

Figure 1. Using the Accu-Sharp Jig to grind the

bevel of a flat chisel.

Inventory

After removing the contents of the shipping pack- age, lay them out and refer to Figure 2 to inven- tory the components.

Tool

Clamping

Jig

Auxiliary

Table

Mounting

Screws

Figure 2. Model G4570 inventory.

Warning: No portion of this manual may be reproduced in any shape Or form without the written approval of Grizzly Industrial, inc.

#TS11341 printed in CHINA