Lubrication
The bearings used in the motor, the wheels and the blade guides are shielded and
The rod on which the saw bow pivots needs an occasional shot of light oil to keep it moving smoothly.
The gear box should not need changing unless the oil becomes contaminated or leaks. To check the oil, lower the saw bow down all the way and wait a few minutes for the oil to drain down. Open the oil cap on top of the gearbox. The gear case is full when the oil is up to the bottom of the filler hole. Use 90W gear oil if it becomes necessary to change or add to the oil.
Coolant System
The coolant system must be properly filled with the proper mix of coolant and water in accor- dance with the coolant manufacturer’s specifi- cations. The coolant will need to be replaced periodically as the bandsaw is used more. Some coolant types also breakdown over time, or need additives to reduce the growth of bacteria or fun- gus in the solution.
There is a filter in the bottom of the coolant pump which will need periodic cleaning or replacement. Any time coolant flow does not seem sufficient, check the coolant sump for level, and check the pump filter.
Miscellaneous
Always be aware of the condition of your bandsaw before using it. Routinely check the condition of the following items and repair or replace as nec- essary.
1.Worn or damaged blade.
2.Worn switches.
3.Loose mounting bolts.
4.Worn or damaged support bearings or guide bearings.
G1011 7" x 12'' Bandsaw |