Panasonic SC-AK450 English, Preparing the remote control, Demo function

Optional antenna connections

Use outdoor antenna if radio reception is poor.

Note:

Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.

ENGLISH

FM outdoor antenna

(

Rear panel of this unit

AM outdoor antenna

Rear panel

of this unit FM outdoor antenna

(not included)

75 Ω coaxial cable (not included)

AM outdoor antenna (not included)

5-12 m

(16 - 40 ft.)

AM loop antenna (included)

DANSK

•	Disconnect the FM indoor antenna.	•	Run a piece of vinyl wire horizontally across a window or
•	The antenna should be installed by a competent		other convenient location.
	technician.	•	Leave the loop antenna connected.

Preparing the remote control

■Batteries

AA/R6/LR6	• Insert so the poles (+ and –) match those in the remote control.
	• Remove if the remote control is not going to be used for a long period of
	time. Store in a cool, dark place.
	• Replace if the unit does not respond to the remote control even when held
	close to the front panel.
	• Do not use rechargeable type batteries.
	• Mishandling of batteries in the remote control can cause electrolyte
	leakage, which may cause a fi re.
	• If electrolyte leaks from the batteries, consult your dealer.
	Wash thoroughly with water if electrolyte comes in contact with any part of
Adhesive	your body.
tape	Do not:

•mix old and new batteries.

•use different types of batteries at the same time.

•heat or expose batteries to fl ame.

•take apart or short circuit the batteries.

•attempt to recharge alkaline or manganese batteries.

•use batteries if the covering has been peeled off.

•put heavy objects on the remote control.

• spill liquids onto the remote control.

■Use

Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m (23 feet) directly in front of the unit.

Refer to page 6 for the remote control sensor position.

FRANÇAIS

LANG - 4

DEMO function

-+

7, STOP, –DEMO

When the unit is fi rst plugged in, a demonstration of its functions may be shown on the display.

If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

Press and hold [7, STOP, –DEMO].

The display changes each time the button is held down.

NO DEMO (off) Ô DEMO ON (on)

While in standby mode, select “NO DEMO” to reduce power consumption.

Note:

DEMO function cannot be turned on when DIMMER is on.

LANG - 5

RQTV0191

5

RQT8043