SET UP
UnpackingCharging
Your jump starter/compressor left our warehouse in a carefully packed crate or box. If you discover damage after you have signed for delivery, please immediately call Customer Service at (570)
Save the containers and all packing materi- als for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condition of the shipment, you should inventory the equipment.
Inventory
After you have unpacked the carton you should find the following.
Model H6310 Inventory (Figure 1)
A. | Main Unit | 1 |
B. | Charging Adapter Cord | 1 |
C. | 12V Output Cord | 1 |
D. | Securing Strap | 1 |
The Model H6310 is shipped with a charg- ing adapter that fits neatly into the storage compartment.
To charge the Model H6310:
1.Remove the charging adapter from the storage compartment, and plug it into a 110V electrical outlet.
2.Turn the main power switch ON, and press the "Test" button so the voltage meter shows the charge.
3.Plug the adapter cord into the "Recharge" socket.
—The red light will light up if the Model H6310 is charging.
—If the red light will not light up, the Model H6310 is fully charged.
4.Allow the Model H6310 to charge until the red light turns off or until the volt- age meter reaches 13V.
5.Disconnect the Model H6310 from the charger.
NOTICE
DO NOT charge the Model H6310 for longer than 24 hours or internal dam- age may result.
Model H6310 Jump Starter/Compressor |