Grizzly H3370, H3371 Before Operating This Equipment, Safety Instructions For Pneumatic Tools

Page 3

SAFETY

For Your Own Safety Read Instruction Manual

Before Operating This Equipment

The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words which are intended to convey the level of importance of the safety messages. The progres- sion of symbols is described below. Remember that safety messages by them- selves do not eliminate danger and are not a substitute for proper accident pre- vention measures.

Indicates an imminently hazardous situation which, if not avoided, WILL result in death or serious injury.

 

 

 

 

Indicates a potentially hazardous situation which, if

 

 

 

 

 

 

 

 

not avoided, COULD result in death or serious injury.

 

 

 

 

Indicates a potentially hazardous situation which, if

 

 

 

 

 

 

 

 

 

 

 

 

 

 

not avoided, MAY result in minor or moderate injury.

 

 

 

 

It may also be used to alert against unsafe practices.

 

 

 

 

 

 

 

 

 

NOTICE

 

This symbol is used to alert the user to useful infor-

 

 

mation about proper operation of the equipment.

Safety Instructions For Pneumatic Tools

1.KEEP ALL SAFETY DEVICES IN PLACE and in working order.

2.REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and adjusting wrenches are removed from tool before operation.

3.KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.

4.DO NOT USE IN DANGEROUS ENVIRONMENT. DO NOT use pneumatic tools in damp or wet locations, or where any flammable or noxious fumes may exist. Keep work area well lighted.

5.KEEP CHILDREN AND VISITORS AWAY. All children and visitors should be kept at a safe distance from work area.

6.MAKE WORKSHOP CHILD PROOF with padlocks, master switches, or by removing air hoses from tools.

7.DO NOT FORCE TOOL. It will do the job better and safer at the rate for which it was designed.

8.USE THE RIGHT TOOL. DO NOT force tool or attachment to do a job for which it was not designed.

9.DO NOT USE UNDER THE INFLU- ENCE OF DRUGS OR ALCOHOL.

Model H3370/H3371 Air Compressors

-1-

Image 3
Contents Model H3370/H3371 Pancake and HOT DOG AIR CompressorsPage Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Wear Approved Hearing Protection Read this Entire Manual Before Operating the Compressor Additional Safety For Air CompressorsCommentary Introduction and SET UPUnpacking Site Placement Circuit Requirements 110V Operation GroundingExtension Cords Duty Cycle Preparing for USEStarting Delivered Pressure Air Release AIR ControlPressure Regulator Model H3370/H3371Air Compressors Tank Pressure RegulatorTo connect air tools to your air com- pressor Connecting ToolsEach Use MaintenanceHours of Use After FirstEvery 300 Hours Storage When storing your air compressor, fol- low these guidelinesProblem Cause Action TroubleshootingEarly, test pressure relief and repair or Model H3370 Pancake Air Compressor Model Stator 115V/60HZ Model H3371 Hot Dog Air Compressor Valve Patch Stator 115V/ 60HZ Model H3370/H3371Air Compressors Warranty and Returns Warranty Card Place Stamp Here