Preparing for use
Note! Always switch on the delta sander before bringing it into contact with the workpiece material.
Removal:
j Press the release button 5 of the dust extraction |
box for internal vacuum extraction 4 and |
Switching on the device:
jMove the ON / OFF switch into the “ON” position.
Switching off the device:
jMove the ON / OFF switch the “OFF” position.
8
8
downwards
upwards into
withdraw it towards the rear of the device. |
QReducer piece
Connection:
j | Push the reducer piece |
| into the adapter | ||
3 | |||||
| port |
| . | ||
j | 2 | ||||
Push the hose of a suitable dust extraction de- | |||||
QVacuum dust extraction
WarnING! Danger of fire! There is the danger of fire when working with electrical devices that have a dust box or can be connected to a vacuum cleaner. Under certain conditions the wood dust in the dust extraction bag (or in the vacuum‘s dust bag) may ignite, e.g. as a result of flying sparks generated when abrading metals or metal objects left in wood. This can happen partic- ularly if the wood dust is mixed with paint residue or other chemicals and the abraded particles are hot from prolonged abrasion. Therefore you must empty the device’s dust collection box and the vacuum cleaner’s dust bag before taking a break or stopping work and always avoid overheating of the abraded particles and the device.
Wear a dust mask!
WarnING! Always pull the mains plug is out of the socket before doing any work on the device.
QDust box for internal vacuum extraction
Connection:
jPush the dust box for internal vacuum extraction 4 on to the
10 GB/IE/CY
vice approved for that purpose (e.g. a workshop |
vacuum cleaner) on to the reducer piece 3 . |
Removal:
jPull the dust extraction device hose off the reducer piece 3 .
jPull off the reducer piece 3 .
QAttaching / detaching sanding sheets
WarnING! Always pull the mains plug is out of the socket before doing any work on the device.
Attaching:
jSanding sheets are attached to the backing plate 7 by means of the hook and pile fastening.
Detaching:
jSimply pull the sanding sheet off the backing plate 7 (see Fig. C).
QRotating the backing plate
WarnING! Always pull the mains plug is out of the socket before doing any work on the device.
jRotate the backing plate 7 into the desired position (see Fig. D).
Sanding and surfaces:
The sanding output and the quality of the surface finish are determined by the grade of grit on the sanding sheet.