General safety advice for electrical power tools / Operation
a stop before setting down the oscil- lating sander.
JAlways pull the power plug out of the socket for all work pauses, before any work on the appliance (e.g. changing the sanding paper) and when not in use.
JThe appliance must always be kept clean, dry and free of oil or lubricat- ing greases.
QOriginal ancillaries / and accessories
JOnly use accessories and tools that are specified in the operating instructions. The use of tools and accessories other than those recommended in the operating instructions could lead to an increased risk of personal injury for you.
QOperation
QOperation
Take note of the mains voltage! The voltage must agree with the information on the type plate of the appliance (appliances that are designated as 230 V can also be connected to 220 V).
QSwitching On and Off
Switching on intermittent function:
jPress the ON / OFF switch 1 .
Switching off intermittent function:
jRelease the ON / OFF switch 1 .
Switching on continuous operation :
jPress the ON / OFF switch 1 , hold it pressed and press the locking button 2 .
Switching off continuous operation:
jPress the ON / OFF switch 1 then release it again.
10 GB/IE/CY
QSetting the oscillation speed
You can set the desired oscillation speed as needed with the oscillation speed selector 10 . The required oscillation speed depends on the material being worked and can be determined through practical tests.
QAttaching a sanding pad
WarnING! Before performing work on the appliance, always disconnect the power.
NoTE: Before attaching a new sanding pad 9 , remove dust and dirt from the sanding plate 8 .
Sanding sheets with hook and loop fastening:
jFix one side of the sanding sheet 9 flush with one side of the backing plate 8 .
jThen attach the sanding sheet 9 to the back- ing plate 8 and press it firmly into place.
Sanding sheets without hook and loop fastening:
jOpen the two clamping levers 7 .
jPush one end of the sanding sheet 9 under the open clamping bar 6 and clamp the sheet firmly in place by locking the clamping lever 7 back in place.
jRepeat this procedure at the other end.
Various materials require different grit values. You can read which grit value is best suited for which work in our recommendations under “Instructions, tips and tricks”.
QVacuuming dust
WarnING! Fire hazard! A risk of fire exists when working with electrical appliances that have a dust
collection box 4 or can be attached to a vacuum cleaner via an external suction adapter! Under cer- tain conditions the sanding dust in the dust box (or in the vacuum’s dust bag) may