3.Insert the required size Fasteners (3/4” - 2” L
4.Slide the Magazine back into place until it clicks.
General Operating Instructions
1.Before each use, test the Tool, as directed in the prior section.
2.If an automatic oiler is not used, add a few drops of Pneumatic Tool Oil to the airline connection before use. Add a few drops more after each hour of continual use.
3.Grip the Body (24) of the Nailer with both hands and press the nose piece against the surface you wish to fas- ten. Be sure to keep hands, fingers and other body parts away from Nozzle.
4.Push the nose piece on a scrap material, preferably the same thick- ness and type of material as the workpiece. Press the Trigger (42) to activate the Nailer. Performing this
5.Grip the Body (24) of the Nailer with both hands and press the Nozzle against the surface you wish to fas- ten. Be sure to keep hands, fingers and other body parts away from the Nozzle.
6.Press the Trigger (42) to activate the Nailer.
7.To avoid indenting or marring when working on the face of fine surfaces,
use the supplied Plastic Cap (86) on the Safety.
8.If the tool requires more force to accomplish the task, verify that the tool receives sufficient, unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum air pressure rating of this tool.
CAUTION! To prevent tool and accessory failure, resulting in injury:
Do not exceed the tool’s maximum air pressure rating.
If the tool still does not have sufficient force at maximum pressure and sufficient airflow, then a larger tool may be required.
9.To prevent accidents, turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the trigger after use. Clean external surfaces of the tool with clean, dry cloth, and apply a thin coat of tool oil. Then store the tool indoors out of children’s reach.
User-Maintenance
Instructions
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation, BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams):
Rev 09d, 09l
SKU 66902 | For technical questions, please call | Page 11 |