Global Machinery Company ATBR1650K instruction manual Preparing the tool

Page 11

Preparing the tool

Tool lubrication

This finish nailer requires lubrication BEFORE initial use and BEFORE and AFTER each additional use throughout its life.

1.Disconnect the air hose, turn the finish nailer so the air inlet (3) is facing up. Place 3-4 drops of non detergent oil into the air inlet. Do not use air tool oil as it contains solvents which will damage the nailer’s internal parts.

2.Lubricate the drive safety cover & slide guide (8), trigger (2) and magazine slide mechanism periodically.

Apply a few drops of oil to the trigger mechanism.

Apply a thin coat of lightweight grease to safety slide guides.

3.After lubrication, run brad nailer briefly. Wipe off any excess oil from the adjustable deflector exhaust (1). The work surface can become damaged by excessive lubrication.

4.Finish nailer repairs must be done by a qualified and experienced service dealer.

Place a few drops of non-detergent oil into air inlet before each use.

Apply a few drops of oil to sliding mechanism of the magazine.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Finishing Nail Gun Kit Contents Dear Customer Description of symbolsSpecifications General safety instructions for air toolsPage Risk of fire or explosion Important safety instructions Risk of eye or head injuryWhat could happen How to prevent it Risk to injury Risk of loss of hearingSense. Do not operate tool when you are tired Maintenance or tool changesService representative Using or carrying the brad nailerRisk of electric shock Risk of cut or burns Risk of entanglementKnow your product Preparing the tool Operation Clearing a jam Power sourceAdjusting the exhaust direction Adjusting the fastening depthTroubleshooting Page Save this Manual for future reference
Top Page Image Contents