Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 9 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
INCLUDED ACCESSORIES
3mm Hex Wrench | Tool Oil |
4mm Hex Wrench | Assorted |
*NOTE: Although spare assorted
these parts are for installation by a qualified technician only.
Operation
For best service, you should incorporate an oiler, regulator, and inline filter, as shown in the diagram below. Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.
Nailer
Note: To connect this tool, we recommend a quick coupler/adapter (not included). Coupler/ adapters are available at Harbor Freight Tools. For smoother operation, put
Testing the Contact Safety Trip Mechanism
Warning: Even though the nailer should be empty during this procedure, ALWAYS point the nailer at a piece of scrap wood when testing.
1.Make sure the tool is disconnected from the power supply.
2.Completely empty the magazine of nails.
3.The Nailer should not fire if the nose is not depressed against the workpiece.
4.Check that the Trigger
5.Connect the air supply to the tool at the Air Plug
SKU 42528 | For technical questions, please call | Page 5 |