TestingThe Single Sequential SafetyTrip Mechanism
Warning: Even though the nailer should be empty during this procedure, ALWAYS point the Nailer at a piece of scrap wood when testing.
1.The Nailer should not fire if the nose is not depressed against the workpiece. This tool has a single sequential safety trip mechanism, which is designed to prevent inadvertent firing. The tool will only fire if the Safety (38) is resting on the workpiece prior to pulling the Trigger (44).
2.Make sure the tool is disconnected from the air supply.
3.Empty the magazine of nails or staples.
4.Check that the Trigger (44) and the Safety (38) on the nose of the tool, move freely, without sticking.
5.Connect the air supply to the tool at the Air Plug (79) and set at the recommended 70- 125 PSI, and not over the maximum 125 PSI.
6.Test the tool by depressing the Safety (38) on the nose of the tool against the workpiece without pulling the Trigger (44). The tool must not cycle (fire). If it cycles (fires), stop immediately and take the tool to a qualified service technician for repair.
7.Hold the tool away, or off of the workpiece. The Safety (38) or nose of the tool should return to its original position. Squeeze the Trigger (44). The tool should not cycle (fire). If it cycles (fires), stop immediately and take the tool to a qualified service technician.
8.Depress the Safety (38) against the workpiece and squeeze the Trigger (44). The tool must cycle (fire) once only. Release the trigger and squeeze it again. The tool must cycle (fire) again only once. With the Trigger held, carefully lift the nailer and press it against the workpiece again. The tool must not cycle (fire). If it fails to act in the manner explained in bold, have it repaired by a qualified service technician.
Loading Nails
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN RELOADING OR DOING ANY OTHER MAINTENANCE ONTHISTOOL. Other people in the work area must also wear ANSI approved impact safety goggles.
Warning! Make sure the Nailer is not attached to the air hose whenever loading the tool.
1.CAUTION: Make sure to keep the Framing Nailer pointed away from you and others at all times. Always disconnect the Framing Nailer from its air supply before loading nails. Do not load nails with the Trigger (part #44), or Bracket B (part #35), or Safety (part #38) depressed. (See Figure B)
2.Pull the Feeder Shoe (part #52) all the way to the rear, until it latches.
(See Figure B.)
REV 11/06
SKU 04041 | For Technical Questions, Please Call | Page 6 |