
the mitre table to the desired position. The mitre table features positive click stops for quick setting of common mitre angles.
WARNING. Be sure to tighten the mitre table locks before making a cut. Failure to do so could result in the table moving during the cut and cause serious personal injury.
Bevel lock
The bevel lock (12) is used to set
the blade at the desired bevelH angle (fig. H). The mitre saw bevel
cuts from 0° to 45° to the left. To adjust the bevel angle loosen the bevel lock and adjust the saw arm to the desired bevel angle.
WARNING. Be sure to tighten the bevel lock before making
a cut. Failure to do so could result in the saw arm moving during the cut and cause serious personal injury.
Spindle lock button |
| ||
I | |||
The spindle lock button (25) | |||
| |||
prevents the blade in the saw |
| ||
from rotating (fig. I). Depress and |
| ||
hold the spindle lock button while |
| ||
installing, changing, or removing |
| ||
the blade. |
| ||
Rotating lower |
| ||
| |||
blade guard |
|
| |
| J | ||
The rotating lower blade guard |
| ||
|
| ||
(9) provides protection from both |
|
| |
sides of the blade. It retracts |
|
| |
over the upper blade guard (8) |
|
| |
as the saw is lowered into the |
|
| |
workpiece workpiece (fig. J). |
|
| |
|
|
|
Dust bag | K |
The dust bag (28) fits over the dust extraction port (27) (fig. K). For more efficient operation, empty the dust bag when it is no more than half full. This allows better air flow through the bag.
Turning on and off |
| |
L | ||
1. To turn the saw on depress | ||
| ||
and hold the on/off trigger |
| |
switch (23) (fig. L). |
|
2.To turn the saw off release the on/off trigger switch (23).
Turning on the REDEYE® |
| |
laser line generator |
| |
M | ||
The REDEYE® laser line | ||
generator emits an intense |
| |
narrow beam of pure red light to |
| |
guide you as you cut. It improves |
| |
operator cutting vision, enables |
| |
faster |
| |
and improves safety. To turn on |
| |
the laser line press the laser light |
| |
|
on/off switch (2) (fig. M). To turn off the laser press the laser light on/off switch (2) one more time.
Setting the table square with the blade
1. Make sure that the electrical
plug is removed from theN power point.
2.Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the transport position (fig. N).
3.Loosen the mitre locks (18).
10