17.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
18.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
19.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.
20.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
Additional safety rules for cut off saws
WARNINGS.
Always wear eye protection.
Do not use cutting wheels, the maximum permissible speed of which is below the RPM value stated on the tool.
•Check the cut off disc before mounting it into the saw. Strike the disc with a wooden handle whilst balancing the disc on your finger. Listen for the ring. If the tone is dull, do not use the disc. It may be cracked.
•When the disc is installed, stand to one side, out of line with the disc, and run the tool for at least a minute to make sure that it is not faulty. Always stay out of line of the disc when using the saw.
•Do not use a cut off disc marked with a lower RPM than that of the no load speed shown on the rating plate of the tool.
•Check that the mains voltage matches that given on the rating plate before plugging in the tool.
•Ensure that the work piece is held tight in the vice.
•When cutting through long material, ensure that it is supported properly by packing up each end to match the height of the vice.
•Use only good quality cut off discs as poor quality discs tend to glaze up which can cause unnecessary load on the motor and resulting damage.
•Let the disc do the cutting at a reasonable feed. If too much pressure is applied the motor will be overloaded causing the disc to slow resulting in inefficient cutting and possible damage to the motor.
•When operating the cut off saw, use safety equipment including safety goggles or shield, ear protection, dust mask and protective clothing including safety gloves.
WARNING. Before connecting a tool to a power source (mains switch power point receptacle, outlet, etc.) be sure that the voltage supply is the same as that specified on the nameplate of the tool. A power source with a voltage greater than that specified for the tool can result in serious injury to the user, as well as damage to the tool.
5