Using the parallel fence
The parallel fence (9) allows you to make parallel cuts in a sheet of wood, all at the same width.
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1. Loosen the parallel fence locking knob (8).
2.Slide the parallel fence (9) through the slots in the base plate (12).
3.Adjust the parallel fence to the required width and secure it in position with the parallel fence locking knob (8).
4.Ensure that the parallel fence rests against the wood along its entire length to give a consistent parallel cut.
Changing the blade
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Rotate the saw blade by hand whilst depressing button
(17)until the blade locks.
2.Whilst depressing button (17), turn the blade bolt
3.Remove the outer blade flange and the blade bolt.
4.Raise the lower blade guard (11) using lever (10). Remove the saw blade from the inner flange and pull out the blade.
Note. Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe a drop of oil onto the inner and outer flange where they will touch the blade.
5.Mount the new saw blade onto the spindle and against the inner flange.
6.Replace the outer flange and tighten the blade bolt.
WARNING. The direction in which the blade rotates has to be the same as the direction of the arrow marked on the housing.
Ensure that button (17) is released. Before using the saw again, check that the safety
devices are in good working order.
10