•Drain the moisture from the tanks daily. It will help prevent corrosion.
•Pull the ring on the safety valves daily to ensure that it operating properly and to clear any possible instructions.
Note. This unit has two safety release valves (one on each tank). Ensure both are checked daily.
•Keep the compressor at least 300mm from the nearest wall to ensure adequate ventilation for cooling purposes.
•Prior to transporting the compressor make sure that the pressurised air is bled from both tanks. Ensure that the removable tank is correctly connected. Also check that the compressor is firmly secured.
Note. Never transport pressurised tanks. Even when transporting the removable air supply it must be empty of all air.
•Protect the air hoses and cordset from damage. Inspect for weak or worn spots regularly and replace if necessary.
•Prior to using the removable tank as a temporary air supply make sure that you place it down on a level surface and have a firm grip on the air hose prior to use.
•Do not use an extension cord with this product. Use additional air hose instead of an extension cord to prevent power loss and possible damage to the motor. Use of an extension cord voids the warranty.
•After long working periods external metal parts could be hot.
•Always shut off the compressor at the on/off switch by lifting the lever to the off position before switching off the power or removing the power plug.
•Check the oil level before starting the compressor every time.
•Make sure the compressor is on a level surface prior to checking the oil level.
•The oil level is required to be at the red dot on the oil level sight glass prior to use.
•Use only oil grade specified in this instruction manual.
Note. The compressor is supplied empty of oil. It must be filled with oil before first use.
•After using the compressor, switch off the on/off switch, disconnect the power supply and open the outlet valves on both tanks to release the pressure.
•Ensure that the lubricating oil is clean and that the oil level is maintained at the correct level. Replace the oil as indicated in the Maintenance section of this Manual.
•Use safety equipment including safety goggles or shield, ear protection, breathing or respirator mask and protective clothing.
Wear goggles
Wear earmuffs
Wear a breathing mask
Never apply air from any of the air outlets from this compressor directly on to any part of a person’s body. Do not attempt to block any of the air outlets with your finger or any part of your body.
The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or injury resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool’s construction and design:
•Damage to the lungs if an effective breathing mask is not worn.
•Damage to hearing if effective earmuffs are not worn.
•Damage to the eyes if effective safety goggles or shield are not worn.
7