Using the parallel fence guide
The parallel fence allows you to make parallel cuts in a sheet of wood, all at the same width.
Caution. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Slide the parallel fence (9) through the slots in the base plate.
2.Adjust the guide to the required width and secure it in position with the locking knob (8).
3.Ensure that the guide rests against the wood along its entire length to give a consistent parallel cut.
Dust extraction
You can connect the tool to a vacuum system via the dust extraction port (14).
Changing the blade
Caution. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Rotate the saw blade by hand whilst depressing the spindle lock button (17) until the blade locks.
2.Turn the blade bolt
3.Remove the outer blade flange and the blade bolt.
4.Retract the lower blade guard (11) using the lever (10).
5.Remove the saw blade from
the inner flange and pull it out.
6.Clean the saw blade flanges thoroughly before mounting the new saw blade.
7.Mount the new saw blade in reverse order and tighten the blade bolt.
Warning. The direction in
which the blade rotates has to be the same as the direction of the arrow marked on the housing.
8.Ensure that the spindle lock button (17) is released.
9.Before using the saw again, check that the safety devices are in good working order.
Important. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.
WARNING: Plug the machine in to a power socket and run the saw under no load to check that it runs smoothly before using it to cut any material.
10