Grizzly T20568 Clearing Jammed Nails, To clear a jammed nail from the dis- charge area

Page 12

Clearing Jammed

Nails

A jammed nail must be cleared before using the nailer again.

To clear a jammed nail from the dis- charge area:

1.DISCONNECT NAILER FROM THE AIR SUPPLY!

2.Release the catch lever and slide the magazine pusher back.

3.Remove the nail stick from the maga- zine.

4.Open the nailer nose by removing the rubber nose tip, depressing the nose release mechanism, and opening the nose cover as shown in Figure 7.

Nose Release Clip

Nose Tip

Nose Cover

Figure 7. Nose opened to clear a jam.

5.Dislodge the jammed nail with a tool that will fit in the slot on the underside of the nose.

6.Throw the damaged nail away and insert a new nail stick that only contains clean, undamaged nails. DO NOT use dirty or damaged nails!

7.Slide the pusher back until it locks into position.

-10-	T20568 11⁄4" Brad Nailer

Image 12

Contents Model T20568 11⁄4 Brad Nailer Safety Safety Instructions For Pneumatic ToolsBefore Operating This Equipment Mation about proper operation of the equipmentAlways USE Safety Glasses Additional Safety Instructions for Nailers T20568 11⁄4 Brad Nailer Introduction Manual Accuracy Contact InfoMachine Data Set up UnpackingInventoryModel T20568 Inventory Figure Compressed Air System Safety Nose Mechanism To do thisOperationS LoadingOperating To load your nailerAdjusting Depth To adjust the depthClearing Jammed Nails To clear a jammed nail from the dis- charge areaReplacing Pistons Rings Cleaning & Lubrication CleaningLubricatingTroubleshooting Symptom Possible Cause SolutionT20568 Parts Breakdown T20568 Parts list DescriptionWarranty and Returns Warranty Card Place Stamp Here Name Street CityStateZip