Additional Safety Instructions for Nailers
1.HAND INJURIES: Do not place your hands near the nail point of entry. A nail can deflect and tear through the surface of the workpiece, puncturing your hand or fingers.
2.COMBUSTIBLE GASES: Never connect the nailer to pressurized oxygen or other combustible gases as a power source. Only use fil- tered, lubricated, and regulated compressed air.
3.SAFE HANDLING: Never point the nailer at others! Do not keep the trigger pulled when loading fasten- ers, carrying, or holding tool. Carry the nailer only by the handle, never by any other part. Do not carry the nailer by the air hose. Disconnect the nailer from the air hose when going up and down ladders.
4.CLEANING: Never use gasoline or other flammable liquids to clean the nailer; vapors in the nailer will ignite by a spark and cause it to explode.
5.HOSE: Make sure your air hose is designed for the tool in use, is in good condition, and is long enough to reach your work with- out stretching. However, an overly long air hose in the work area may be a tripping hazard.
6.OPERATING QUESTIONS: If you are not sure about the intended operation, stop using the nailer. Seek formal training or research sources that specialize in pneu- matic tools.
7.MAINTENANCE: Always discon- nect air from the nailer when ser- vicing or installing nails. During maintenance, a nailer connected to air may fire accidentally, caus- ing serious personal injury.
8.COMPRESSED AIR RATING: Do not connect the nailer to com- pressed air that exceeds 120 PSI.
9.CHECK VALVE: Do not use a check valve or any other fitting that allows air to remain in the tool.
H7665 21° Round Head Framing Nailer |